Can You Reuse an LED Grille Badge on Another Car?
Moving an LED grille badge from one car to another is a new fitment decision, not a guaranteed transfer. The badge may be removable, but the product listing does not promise that its old holes, wiring route or backing plate will suit a different grille. Start with the exact badge record you own, then compare the new vehicle's usable face and rear access with that record.
These images identify two exact products. They are not installation photographs and do not establish compatibility with either vehicle.
Separate the badge from the old vehicle
Read the original product page before you remove anything. The BMW ///M Type 1 listing says its package includes one ///M LED badge, wiring, a mounting plate, fixing nuts, cable ties, instructions and a protective box. The Dodge R/T Type 1 Small listing says it includes an LED badge with wiring, two mounting screws, a backing plate and fixing nuts. Those are source-specific included-item statements for new orders; they are not a promise that used parts will remain undamaged after removal.
Save the exact title, handle and product link with your badge. Photograph the wiring and rear hardware before removal, and keep every part that the listing names. If a screw, plate or cable is missing, record that gap instead of assuming another product's hardware is interchangeable.
Compare the new grille with the exact assembly
| Product record | Listed dimensions | Source mounting detail |
|---|---|---|
| BMW ///M Type 1 | 130 × 54 × 52 mm | Two screws, mounting plate and fixing nuts |
| Dodge R/T Type 1 Small | 105 × 46 × 52 mm | Two screws, backing plate and fixing nuts |
In both records, the third number is overall depth including mounting hardware. On the new car, compare the exact face width and height with the open grille area, then check the position of the full 52 mm assembly, including its mounting hardware, so it does not contact braces, shutters, sensors or trim. The old vehicle's opening and holes do not answer that question for the new one.
Recheck power instead of moving assumptions
Both listings describe connection to a suitable ACC, DRL or low-beam circuit and say to match the power supply to the badge's rated voltage. That is useful product guidance, not proof that the second car has the same connector, circuit behavior or accessible route. Have the new location and wiring assessed separately if the circuit or rear access is uncertain.
When to pause the transfer
- Keep the exact product record and current condition of the badge together.
- Measure the new grille's usable face, not the whole grille opening.
- Check rear clearance for the 52 mm assembly and the backing hardware.
- Confirm the new vehicle's circuit and protected wire route independently.
- Ask about replacement hardware or a new product if the original parts are damaged or missing.
A badge that looks reusable on a bench may still be wrong for the new opening or rear structure. Treat the move as a fresh product-and-vehicle review, and keep the exact LED Grille Badges collection link nearby when comparing a replacement design.
